Original Billski Mod Tail Light Installation Instructions

749 Red River Road
Rock Hill, SC 29730
Call us toll free at:
1-866-897-0677
Billski182@comporium.net

SHIPPING
ON ALL ORDERS OVER $199.00
(U.S. Only)

Now Accepting

Not a Paypal user? - No problem. Use your credit card - Just choose other forms of payment during checkout.

Review Cart ¨ Check Out Now

Send to a friend

THE ORIGINAL BILLSKI MOD

Installation Instructions ¨ Frequently Asked Questions ¨ Testimonials ¨ Gallery

The mod is pretty easy to do. It requires the tool list below: Allen Wrenches (5mm & 10mm), Phillips Head Screw Driver, Socket Set, Wire Cutters, Electrical Tape. Almost everything you need can be found in your motorcycle tool kit. It isn't a MUST that you remove the rear fender, but it will MAKE THE JOB A WHOLE LOT EASIER. Once you get the seat and fender off there are two 5mm allen heads and one 10mm nut to remove.

Heads up on the allen heads, a number of people have found them to be extremely tight! At least one perhaps two guys had to put heat on them. Mine came right off.

Check out the diagram below for more information.

Once you get the Stock light off, cut the stock wires wherever you feel like. Splice the wires in the following pattern Black=Brown, Red=Yellow/Green, Yellow=Green.

Press the brake to see if the light is working. Lately I have gotten some lights that have different wiring. If the above wiring doesn't work, try this combination instead:

Black=Green, Red=Yellow/Green, Yellow=Brown

After it’s connected, wrap wires with electrical tape. Reassemble the bike.

If you have any questions you can e-mail or call 1-866-897-0677.